How different concentrations of fertiliser affects the growth of a plant.
The experiment was started on the 12/3/14.
Introduction/research:
From my own knowledge I know that Fertilisers are used on plants to help them grow faster, bigger and greener. Over fertilising a plant will usually result in the plant dying or making the plant grow slower and shorter whilst applying not enough fertiliser will stop the plant from growing to its full potential. From research I have found that in order to help a plant grow they need certain chemicals. The most important chemicals to help a plant grow are potassium, phosphorus and nitrogen, these chemicals are usually found in most fertilizers.
Aim:
To find out what happens to the growth of a plant when different concentrations of the recommended amount of fertiliser, are used on the plants.
Hypothesis:
As the amount of fertiliser used to water the plant from the recommended amount increases or decreases the plants growth will slow down making the height of the plant after the time period of 15 days shorter compared to the growth of the plant that had been watered with the recommended amount of fertiliser. This is because watering the plant with too much or too little fertiliser will slow down or fail to increase the speed of growth because using too much or too little fertiliser slows down the growth of the plant since the plants are being given too much or too little nutrients and chemicals, and when given in the right amounts these chemicals help the plant to grow faster and taller.
Variables:
Independent variable: The Concentration of fertiliser in the water lower and higher than the recommended amount. Using more or less of the recommended amount of fertiliser will change this va...
... middle of paper ...
...0mls of water twice a day so the plant gets 100mls of water daily. Spray the plant once in the morning and once in the evening. Repeat this process for each plant pot.
4. Repeat step 3 for 15 days until results are recorded.
5. On the second day arrange The 15 plant pots into 5 groups with three in each group, label the groups of plants, group 1,2,3,4 and group 5 with the amount of fertiliser used for each group of plant as shown below.
Water the 3 plants in-group 1 with 30% of the recommended amount of fertiliser.
Water the 3 plants in-group 2 with 60% of the recommended amount of fertiliser.
Group 3 is the control group. Water the plants in-group 3 using the recommended amount of fertiliser.
Water the 3 plants in-group 4 using 130% of the recommended amount of fertiliser.
Water the 3 plants in group 5 using 160% of the recommended amount of fertiliser.
Two members of the group were instructed to visit the laboratory each day of the experiment to water and measure the plants (Handout 1). The measurements that were preformed were to be precise and accurate by the group by organizing a standardized way to measure the plants. The plants were measured from the level of the soil, which was flat throughout all the cups, to the tip of the apical meristems. The leaves were not considered. The watering of the plants took place nearly everyday, except for the times the lab was closed. Respective of cup label, the appropriate drop of solution was added to the plant, at the very tip of the apical meristems.
3.) Divide your 30g of white substance into the 4 test tubes evenly. You should put 7.5g into each test tube along with the water.
During week 1 of this experiment, we recorded common components of fertilizers and then went on to find the chemical formulas involved in creating them. The second week we began the process of comparing three authentic ions we had established in the first week to ion samples to discover other properties they might contain. We decided to discover these different ingredients by preforming a serious of tests, which included placing 0.2g solid of both the authentic and the sample fertilizer separately, in order to establish a constant, and dissolved the fertilizer in 20 mL of water, then checked to see if Mg was present in the sample solution. By setting up a constant and preforming a methodical experiment all on the samples given, we demonstrated the ability to correctly establish and preform an experiment and solve the problem at hand, which was distinguishing the contents of the authentic
One thing I could have done to improve my experiment was to have used a more secure lid on the growth tray to have ensured that all moisture would have stayed in the appropriate area. This makes me less confident about my data because there is a possibility that it could have disrupted the moisture levels in the soil and could have minorly diluted or concentrated
The level of Nitric Oxide in the plants were measured by taking samples of the root and the leaves. A dye was applied to the nitric oxide in order for it to be more clear when viewed.
The results from this lab show different results than those hypothesized. The results are as follows: the tomato plant watered with 2 mL per day resulted in an average height of 2.8 cm, the plant watered with 4 mL per day
the plant and kill it, but if the right amount is added then it should
The null hypotheses of the tested plant are that the average mean of the treatment plant would not have a difference on the height of the plant whether it water only to gibberellic acid. It not just a Gibberellic acid, but it has water as well.
10% - 15%. I intend to place a predefined weight of potato cells (0.15g) in varying concentrations of sucrose solution (0%, 20%, 40%, 60%, 80%), to see the effects of osmosis in the cells of a potato in varying levels of sucrose solution. The potato cores will be prepared, weighed and then placed in the solution and left for a certain amount of time, they will then be removed, re-weighed and the difference in weights calc...
For the last 10 seed-species bags, label 2 bags for each GA concentration: 0ppm, 125ppm, 250ppm, 500ppm, 1000ppm (this will give you 2 trials of germination, to increase the reliability of your results).
Materials: You will need 20 Phaseolus vulgaris beans (Bush Beans) and two petri dishes with transparent lids. You will need Eye dropper to administer 10ml of the experimental treatment, Miracle Gro 1x and the
The combined influence of gibberellic acid and amount of sunlight plays an important role in the development of plants. This study is aimed at the model effectiveness evaluation concerning the speed of development of wild type and Rosette Dwarf flowers. The group of flowers were divided into 4 different categories; wild type plants were split into the controlled and experimental group, and the same was done for Rosette Dwarf. The subgroups were formed based on what growth hormone each plant received or didn’t receive. Then the plants were measured each week by how high they grew, and the amount of flowers opened. During the controlled examination, both flowers received extra water, which made up for the amount of water in the gibberellic acid, which was given to the experimental group. After collecting data, the controlled examination allowed us to determine the full effect
You will want to spread them out so that they are not too close. You also want to gather three types of water and set up a schedule for when you are going to water your seeds and check for root growth. If you are going to use a solution that changes every day make sure to keep a bottle of the solution you choose that same day so the concentrations are the same all the time. You want the plants to be moist at all times so you must keep a lid over them or you can use plastic wrap. When you have set up the experiment make sure to check the seeds regularly and record when the seeds start to sprout and how much they have grown.
My goal was to find out which plant would grow faster based on what I watered them with. With the data presented in my tables you can see which plant grew taller than the others. Overall, my experiment did show how planted do not necessarily need to be watered with water to grow healthy and strong. However, I did realize that all three plants were growing at the same rate when given the same amount of fluid. A weakness in my experiment is that I gave each plant 1 ½ tbs of water, soda, and juice. Another weakness may be that the plants did not get as much light they needed to grow bigger, healthier, and stronger. A strength in my experiment is limiting how much sunlight they received even though it was a weakness because we can see if plants
...leaf blade width(FLFLW), basal tiller number(BASTIL), and plant height(PLTHT) were recorded by averaging five plant for each accession.