How To Make Tobacco Bongs

600 Words2 Pages

How To Make Tobacco Bongs

A tobacco bong is another way for someone to smoke tobacco instead of just rolling a cigarette you can just stuff the tobacco in a bowl and smoke it. It is much quicker and easier to do than rolling it in papers. There are many types of tobacco bongs but I'm only going to explain how to make two different types because I dont have enough time to explain how to make all of them. That would take forever. The first type im going to explain how to make is a gravity bong. The other type is a water bong.

A gravity bong is probably one of the easiest and cheapest ones to make. All you have to have is a 2-liter bottle, 5 gallon bucket filled with water, alluminum foil, a sharp knife, tobacco, and a lighter. The first thing you do is take the lid off of the 2-liter bottle and then cut the bottom off with the sharp kinife. Then put the alluminum foil over the top of it and push it down inside of it a little to make a little bowl for the tobacco. Poke about six or seven little holes in the aluminum foil. And that is how you make the gravity bong. To use it all you have to do is put the 2-liter bottle in the water and push it all the way down, but dont push it to far down just push it to where the water is almost up to the aluminum foil and then put the tobacco in it and hold the lighter close to the tobacco and pull up on the bottle. The suction pulls the smoke inside the bottle and when you get the bottle almost out of the water, pull the aluminum foil off and put your mouth over the hole and push the bottle back into the water. The pushes the smoke down your throat.

A honey bear bong is pretty easy to make also. All you have to have is an empty honey bear bottle, a bowl, which costs about a dollar at any smoke shop, 1 foot of 3/4 inch rubber hose, tobacco and a lighter. First you need to be sure most of the honey is out of the bottle but leave about a half inch of it in the bottom. Then you get the

Open Document