To begin we made sure that the spectrophotometer was warmed up and was set to 605 nm while the chloroplast suspension was being made by the instructor. 605 nm was used because this is the wavelength that is the easiest to see transmittance of DPIP in the chlorophyll. The chloroplast suspension is created using spinach leaves that are deveined because the veins contain less chloroplasts. Once the leaves had been deveined they were placed under a light to begin the photosynthesis process. Then the instructor then placed the leaves in a chilled blender. He used a chilled blender because the motor of the blender when in use would generate heat and the heat would in turn cause the leaves to denature. Next, he added .5 M sucrose to the blender which
Analysis of the Absorption of Green Light Versus Red Light Absorption in Spinach Leaves. The goal of the experiment was to determine if green light had less ability to absorb than red light in spinach leaves. This was done by separating the photosynthetic pigments (chlorophyll a, chlorophyll b, carotene and xanthophylls) from one another using paper chromatography. The separated pigments were then analyzed for their absorption spectrum using a spectrographometer.
For part one of the experiment, my team asked the question of which cell fraction of the measured pea seedlings will have a higher ratio of chloroplasts? My group tested for the activity of chloroplasts with three different pairs of cell fractions by two conditions of light and dark in three readings. The first two cell fractions, pellet one and two (P1, P2), are the hard sediments found at the bottom of a tube after it has been centrifuged (which are specimen, like the mitochondria and chloroplast, that are isolated from the rest) (Leicht and McAllister, 2016). The last cell fraction used was the supernatant two (S2), which is just the free liquid surrounding the pellet after the centrifuging of P2 (Leicht and McAllister, 2016). To test for this, DCIP (a chloroplast isolation buffer) was used to
DPIP will be used to determine the rate at which the cholorplasts are being reduced. The spectrophotometer will establish the wavelength of light that penitrats the chloroplast solution in turn determining the amount of electrons reduced. In the dark reactions, the spectrophotometer will measure the amount of light passing through a darker solution of DPIP and chloroplasts. In the light reactions, the lighter solution, caused by reduction of the chloroplasts, will allow a larger amount of light to pass through to the photocell of the spectrophotometer. Thus, the spectrophotometer will prove wheter the light or dark reactions affect the rate of photosynthesis in chloroplasts. We will also be using a reference solution made of water, phosphate buffer, and active chloroplasts. The purpose of this solution will be used to set the transmittance level for the experiment. The control solution, which is different than the reference solution, is comprised of water, phosphate buffer, and DPIP. It will be used to prove that the three element of the solution do affect the results- it is strictly the chloroplasts that are subjected to the light/dark conditions.
The independent factor that will be tested is effect of different wavelengths on the rate of photosynthesis. Wavelength, in particular, is extremely vital because without the suitable wavelength a plant cannot photosynthesise. As a result of the suitable wavelength, the chloroplast is able to convert light energy into chemical energy at a faster rate. The rate of carbon dioxide uptake by the algae balls is used to measure the rate of photosynthesis. The alginate is porous allowing for constant exchanges of gases. The use of hydrogen carbonate indicator changes the color in response to changes in CO2 concentration and the pH of the solution. CO2 dissolved in water forms carbonic acid, which will lower pH. As dissolved CO2 increases and pH falls, the color of the solution changes. Respiration will produce CO2, while photosynthesis will take it up. Therefore, when the rate of photosynthesis is greater than the rate of respiration, the CO2, concentration will decrease, and pH will increase. Under these conditions, the color of the indicator will change. Through these methods, the effect of varying wavelengths on the photosynthetic rates of algae are
... in the chloroplasts in some of their cells. Chlorophyll allows the energy in sunlight to drive chemical reactions. Chloroplasts act as energy transducers, converting light energy into chemical energy. So as the plant has more light the chlorophyll inside the chloroplasts can react faster absorbing in more light for food and energy.¡¨ So this shows my prediction was correct for in my experiment and shown in my result table and graph the more light intensity there is on a plant the higher the rate of my photosynthesis will be. My prediction is very close to what I said the results will be so my prediction was correct and has been proven to be correct in my result table, graph and now explained again in my conclusion.
ABSTRACT: Chloroplasts carry out photosynthetic processes to meet the metabolic demands of plant cells (Alberts, 2008). They consist of an inner thylakoid membrane and a stroma. (Parent et. al, 2008).In this experiment we demonstrate the unique protein compositions of isolated thylakoid and stromal fractions from broken and whole spinach chloroplasts. Because these compartments carry out different metabolic processes, we confirm our hypothesis that performing SDS-PAGE on these fractions will result in distinct patterns on the gels. In isolating and analyzing nucleic acid from broken, whole, and crude chloroplast samples we demonstrate that genes for photosynthetic protein psbA are found in chloroplast DNA, while genes for photosynthetic enzyme
Experiment #1: The purpose of this experiment is to investigate the effects of baking soda and light intensity on the rate of photosynthesis of green spinach leave through the observation of floating disk.
The high rate of absorbance change in blue light in the chloroplast samples (Figure 1) can be attributed to its short wavelength that provides a high potential energy. A high rate of absorbance change is also observed in red light in the chloroplast samples (Figure 1), which can be accredited to the reaction centre’s preference for a wavelength of 680nm and 700nm – both of which fall within the red light range (Halliwell, 1984). Green light showed low rates of photosynthetic activity and difference in change in absorbance at 605nm in the chloroplast samples (Figure 1) as it is only weakly absorbed by pigments, and is mostly reflected. The percentage of absorption of blue or red light by plant leaves is about 90%, in comparison to the 70–80% absorbance in green light (Terashima et al, 2009). Yet despite the high absorbance and photosynthetic activity of blue light, hypocotyl elongation was suppressed and biomass production was induced (Johkan et al, 2012), which is caused by the absorption of blue light by the accessory pigments that do not transfer the absorbed energy efficiently to the chlorophyll, instead direction some of the energy to other pathways. On the other hand, all of the red light is absorbed by chlorophyll and used efficiently, thus inducing hypocotyl elongation and the expansion in leaf area (Johkan et al, 2012).
= > [CH2O} + O2 + H2O, This shows that when the light intensity is increased the rate of reaction will be more quicker he only anomalous result there was, is the one in the 100 watt result the reading after 5 minutes is anomalous because it does not follow the predicted pattern of increasing in the production of gas because it is lower I know from my own knowledge of photosynthesise that when the light intensity is increased the rate of reaction will be more quicker because many plants and trees photosynthesise quicker in stronger light and photosynthesise slower in dimly lit places. The chlorophyll absorbs light energy and enables it to be used by the plant for building up sugar. The overall effect is that energy is transferred from sunlight to sugar molecules.
[IMAGE]Carbon dioxide + water Light Energy glucose + oxygen Chlorophyll [IMAGE]6CO2 + 6H20 Light Energy C6 H12 O6 + 6O 2 Chlorophyll Photosynthesis occurs in the leaves of the plant in the palisade layer. Chlorophyll in the cells in the palisade layer absorb light for photosynthesis. The plant releases the oxygen created in photosynthesis back into the air but it uses or stores the glucose for energy, respiration, growth and repair. The leaves and plants are also specially adapted for photosynthesis in their structure and cell alignment. Preliminary Experiment Apparatus * Piece of Elodea Canadensis * Bulb * Voltmeter * Test tube * Beaker * Box *
The Effect of Light Intensity on the Rate of Photosynthesis in an Aquatic Plant Introduction The input variable I will be investigating is light, as light is just one of the 4 factors required in the green-plant process of photosynthesis. Photosynthesis is the process by which green-plants use sunlight, carbon dioxide, water & chlorophyll to produce their own food source. This process is also affected by the temperature surrounding the plant (the species of plant we experimented with, pond weed, photosynthesised best at around 20 degrees centigrade.) Light, temperature & CO2 are known as limiting factors, and each is as important as the next in photosynthesis. Light is the factor that is linked with chlorophyll, a green pigment stored in chloroplasts found in the palisade cells, in the upper layer of leaves.
Doing experiments and labs with photosynthesis can be a challenge. The floating leaf disk assay technique works well for doing labs. For this experiment you will need baking soda, a plastic syringe, leafs, hole punch, plastic cups, dilute liquid soap, timer and a light source. Prepare 1/8 of a teaspoon of baking soda and 300 ml of water. The baking soda acts as an alternative source of carbon dioxide for photosynthesis. You then add 1 drop of dilute soap to the solution, the soap wets the outside of the leaf allowing the solution to be drawn into the leaf. Avoid having suds if the solution has suds when on the leaf put more bicarbonate into the solution. You then cut ten or more leaf disks for each time you want to do the experiment. The leaf
LAB REPORT 1st Experiment done in class Introduction: Agarose gel electrophoresis separates molecules by their size, shape, and charge. Biomolecules such as DNA, RNA and proteins, are some examples. Buffered samples such as glycerol and glucose are loaded into a gel. An electrical current is placed across the gel.
The second part of this lab deals with photosynthesis. This lab has several experiments. In the first experiment students will learn about the effects that different colored test tubes have on photosynthesis in elodea sprigs.
An Experiment to Investigate the Effect of Light Intensity on the Rate of Photosynthesis. Introduction Photosynthetics take place in the chloroplasts of green plant cells. It can produce simple sugars using carbon dioxide and water causing the release of sugar and oxygen. The chemical equation of photosynthesis is: [ IMAGE ] 6CO 2 + 6H20 C 6 H12 O 6 + 6O2 It has been proven many times that plants need light to be able to photosynthesize, so you can say that without light the plant would neither photosynthesize nor survive.