Wait a second!
More handpicked essays just for you.
More handpicked essays just for you.
Importance of safety in the laboratory
Importance of safety in the laboratory
Importance of safety in the laboratory
Don’t take our word for it - see why 10 million students trust us with their essay needs.
Recommended: Importance of safety in the laboratory
It is important to have lab safety when you are working without anyone else's input, or in a group, and around other individuals. Wearing protection gear is important when vital. At the point when managing something hot dependably make certain to wear gloves and when utilizing a chemical that can hurt your eyes, goggles ought to be worn at unequaled when you are in the lab. Likewise when utilizing a chemical or anything that can leave stains make certain to wear an apron or something that secures your garments. A few chemicals are exceptionally dangerous to the body, therefore when utilizing them generally make the best choice and never taste, touch, or smell the chemical unless the teacher educates you to. Continuously make certain you recognize
There were minimal risks in this section of the practical as glucose is a sugar and is not harmful; however we still wore lab coats and goggles to protect our clothing and eyes from any accidental splashing. We also had to take care when using the pipettes so not to stab ourselves or anyone with them so we had to make sure that we had full concentration on the task and that no one was in too close proximity of you so that they are in danger of getting injured. We also had be careful not to smash any of the glass equipment as this could cause someone to get cut so to prevent this we tried hard not to smash any of the equipment and any breakages are cleared up following laboratory procedures and practices.
We gauged the amount of mass that the fuel lost when raising the temperature of water 20 degrees C. Throughout the experiment we constantly worked with chemicals, boiling water, and liters, turning the Bunsen burners on and off. Because of this, each member of our group were carefully to wear goggles, gloves, a lab coat, and closed toed shoes, with pants down to the ankles. We also cautiously recalled the safety quiz with the locations for the shower and eye flusher in order to make sure we were prepared in case we required their use. Learning to remember these skills grew our knowledge and helped us be cautious for labs to come when working with dangerous
...lothing and equipments in the industry. These will greatly ensure the safety of the employees and hence minimize the injuries. Use of the administrative control and work practices will also lead to the production of quality products safe for consumption (OSHA Quick take, 2010).
OSHA regulations give full disclosure to employees about workplace hazards. Businesses that produce or import chemicals of any sort must review the dangers associated with these chemicals and have them labeled accordingly. They must also prepare material safety data sheets to go with any delivered chemicals. This will describe technical information as well as hazardous effects from exposure and the appropriate protective measures. Any employees wh...
Educators need to be prepared for any accidents that may occur, make sure there is a first aid kit that is well stocked and checked on a regular basis. Food must be handled properly and a well balanced diet should be followed. Food safety guidelines need to followed to preven...
→ Wear clean lab coats; for additional protection in the hood use a fresh, closed front lab coat with gloves that overlap the cuffs. Protective eyewear should be used when appropriate. Lab coats used for cell culture should not leave the cell culture area.
For starters, it is always good to have some form of protection for your hands because they are usually the closest in proximity to the experiment, and therefore usually have the highest chance of being exposed to a chemical. When choosing what protective gloves to wear, first, think about the kind of protection you will need. For example, when conducting experiments that involve really hot or cold temperatures, it is important to select thermal gloves. Additionally, gloves should be selected for based on their compatibility with the chemicals being used. The things to consider when looking for compatibility with chemicals is the gloves breakthrough time, permeation rate, and degradation rating. All of these things affect how well the gloves
What needs to be understood by the modern day student is that when it comes to personal safety measures, they want it available to them while at the same time taking as little precautions as possible to assure it, in other words doing the minimum amount of work needed to assure it. So the
(2014) shed light on two key components for infection control, which includes protecting patients from acquiring infections and protecting health care workers from becoming infected (Curchoe et al., 2014). The techniques that are used to protect patients also provide protection for nurses and other health care workers alike. In order to prevent the spread of infections, it is important for health care workers to be meticulous and attentive when providing care to already vulnerable patients (Curchoe et al., 2014). If a health care worker is aware they may contaminate the surroundings of a patient, they must properly clean, disinfect, and sterilize any contaminated objects in order to reduce or eliminate microorganisms (Curchoe et al., 2014). It is also ideal to change gloves after contact with contaminated secretions and before leaving a patient’s room (Curchoe, 2014). Research suggests that due to standard precaution, gloves must be worn as a single-use item for each invasive procedure, contact with sterile sites, and non-intact skin or mucous membranes (Curchoe et al., 2014). Hence, it is critical that health care workers change gloves during any activity that has been assessed as carrying a risk of exposure to body substances, secretions, excretions, and blood (Curchoe et al.,
Keeping patients safe is essential in today’s health care system, but patient safety events that violate that safety are increasing each year. It was only recently, that the focus on patient safety was reinforced by a report prepared by Institute of medicine (IOM) entitled ” To err is human, building a safer health system”(Wakefield & Iliffe,2002).This report found that approx-imately 44,000 to 98,000 deaths occur each year due to medical errors and that the majority was preventable. Deaths due to medical errors exceed deaths due to many other causes such as like HIV infections, breast cancer and even traffic accidents (Wakefield & Iliffe, 2002). After this IOM reports, President Clinton established quality interagency coordination task force with the help of government agencies. These government agencies are responsible for making health pol-icies regarding patient safety to which every HCO must follow (Schulman & Kim, 2000).
Ties and hair should be tucked out of the way, so they do not make contact with any of the chemicals. It would also be preferable to wear a scientific apron, however this is not essential. We should also try our best not to spill any chemicals, and we must not eat or drink in the lab while dealing with these harmful chemicals, as they can get on our hands. Fair Test To make this experiment a fair test, we need to make sure we do a number of things. In this experiment we are trying to find the rate of reaction using concentration as a factor, so there are a number of things we need to make sure we do to keep it a fair test.
- Take care when handling glassware eg. Thermometers, beakers, stirring rod and test tubes, to minimize breakage keep glassware away from the edges of the bench and be careful when holding and moving them around.
Safety is a primary concern in the health care environment, but there are still many preventable errors that occur. In fact, a study from ProPublica in 2013 found that between 210,000 and 440,000 patients each year suffer preventable harm in the hospital (Allen, 2013). Safety in the healthcare environment is not only keeping the patient safe, but also the employee. If a nurse does not follow procedure, they could bring harm to themselves, the patient, or both. Although it seems like such a simple topic with a simple solution, there are several components to what safety really entails. Health care professionals must always be cautious to prevent any mishaps to their patients, especially when using machines or lifting objects, as it has a higher
The biosafety program ensures the competency of the laboratory staff in safely performing their job through training and documentation of technical expertise. The laboratory staff must manifest professional responsibility for management of research materials complying with appropriate materials management procedures. A hallmark of biosafety practices requires laboratory access to be limited to essential personnel only when work with biological agents is in progress. Biosecurity practices on the other hand ensure that access to the laboratory facility and biological materials are limited and controlled. An inventory system must also be in place so as to control and track biological stocks or other potentially hazardous biological agents in both biosafety and biosecurity programs. For biosafety, the transfer and shipping of infectious biological materials must comply with safe packaging, containment and appropriate transport procedures, while biosecurity ensures that transfers are controlled, tracked and documented relative to the potential risks of the materials being transferred. Both programs must involve the laboratory staff in the development of practices and procedures that fulfills the requirements of biosafety and biosecurity initiatives without hindering research or clinical/diagnostic activities. The success of both of these programs is anchored on a laboratory culture
It’s true what everyone talks about safety – you are the key to your safety, when you do it safely you do it the right way and the best gift you can give to your family is to always stay safe. We have been taught by our parents and teachers to be cautious while doing a number of things. That’s very essential in our daily lives, because one needs to be extra cautious to prevent unavoidable accidents. However, mishaps do happen everywhere in the safest of places, no matter how careful we are in our actions. It is highly unpredictable, what’s going to happen the very next instant. There are numerous incidences we come across like simple trips, falls, cuts due to sharp objects, burns or sudden worsening of a person’s health condition, causing