Varying the Voltage Across a Fixed Value Resistor
For my project I am going to investigate the affects that occur when
varying the voltage across a fixed value resistor. I will observe
things that will happen. I will look at a variety of possibilities,
and hopefully I will find out what happens when the voltage is
changed.
Planning
========
Things the voltage may effect when varied are:
Current
Heat
Resistance
I have decided to change the voltage and measure the current.
Prediction
==========
I predict that if I double the voltage, then the current will also
double. I predict that the voltage will be proportional to current.
The current is the flow of electrons. You can compare a wire to a
water pipe. The flow of electrons is like the flow of water. The
voltage is the push of electrons, which in equivalent would be the
pressure of the water in the pipe.
Therefore if you double the voltage, I think the current will also
double. This is similar to doubling the pressure in the water pipe,
which in affect, will double the flow of the water.
The reason I will test my theory is so I can see if ohm's law was
correct by saying,
"Voltage is proportional to current."
This is one of the main reasons that I think doubling the voltage will
cause the current to double. Resistance is the force that acts against
current.
Fair Test
To make my experiment fair I must do the following:
♥ Turn off the power supply when not in use to prevent over heating.
If this occurs the resistance will increase which would make the
results unfair and unreliable.
♥ Use the exact same equipment if possible throughout the experiment
♥ Use a fixed value resistor to keep the resistance the same/
constant.
Safety
======
There are safety regulations that must be followed in order to keep
Solid A was identified to be sodium chloride, solid B was identified to be sucrose, and Solid C was identified to be corn starch. Within the Information Chart – Mystery White Solid Lab there are results that distinguishes itself from the other 4 experimental results within each test. Such as: the high conductivity and high melting point of sodium chloride, and the iodine reaction of corn starch. Solid A is an ionic compound due to its high melting point and high electrical conductivity (7), within the Information Chart – Mystery White Solid Lab there is only one ionic compound which is sodium chloride, with the test results of Solid A, it can be concluded that is a sodium chloride. Solid B was identified as sucrose due to its low electrical
It was learned that changing the volume of the same substance will never change the boiling point of the substance. However having two different substances with the same volume will result in two different boiling points. The purpose of this lab was to determine if changing the volume of a substance will change the boiling point. This is useful to know in real life because if someone wanted to boil water to make pasta and did not know how much water to
The data which was collected in Procedure A was able to produce a relatively straight line. Even though this did have few straying points, there was a positive correlation. This lab was able to support Newton’s Law of Heating and Cooling.
voltage. But this method can be hard as you might not be able to know
The Effect of the Number of Coils on an Electromagnet On Its Strength Aim: - To establish whether a variation in the number of coils will affect an electromagnet's strength. Scientific Knowledge -. The concept of electromagnets is fairly simple. An iron nail wrapped in a series of coils of insulated wire and then connected to a battery, will enable the nail to pick up paper clips. This is because the current emitted from the battery to the coils magnetizes the nail to the surface.
The null hypothesis at the inception of this lab stated that the breathing rate of a gold fish would not be effected with decreased water temperature around it. The alternate and working hypothesis however stated that decreasing the water’s temperature will decrease the goldfish’s breaths per minute. After preforming the experiment, my results support my original hypothesis as the fish’s breaths per minute did drop when the water temperature lowered. In my group’s experiment, the fish’s breathing rate stayed constant after only decreasing the temperature by 5 ◦C, the breathing rate then plummeted once the water temperature was at 10 ◦C. As a total class, the experiment further supported the hypothesis with the breathing rate per minute dropping
direct conversion of heat into electric energy, or vice versa. The term is generally restricted to the irreversible conversion of electricity into heat described by the English physicist James P. Joule and to three reversible effects named for Seebeck, Peltier, and Thomson, their respective discoverers. According to Joule’s law, a conductor carrying a current generates heat at a rate proportional to the product of the resistance (R) of the conductor and the square of the current (I). The German physicist Thomas J. Seebeck discovered in the 1820s that if a closed loop is formed by joining the ends of two strips of dissimilar metals and the two junctions of the metals are at different temperatures, an electromotive force, or voltage, arises that is proportional to the temperature difference between the junctions. A circuit of this type is called a thermocouple; a number of thermocouples connected in series is called a thermopile. In 1834 the French physicist Jean C. A. Peltier discovered an effect inverse to the Seebeck effect: If a current passes through a thermocouple, the temperature of one junction increases and the temperature of the other decreases, so that heat is transferred from one junction to the other. The rate of heat transfer is proportional to the current and the direction of transfer is reversed if the current is reversed. The Scottish scientist William Thomson (later Lord Kelvin) discovered in 1854 that if a temperature difference exists between any two points of a current-carrying conductor, heat is either evolved or absorbed depending upon the material. (This heat is not the same as Joule heat, or I2R heat, which is always evolved.) If heat is absorbed by such a circuit, then heat may be evolved if the direction of the current or of the temperature gradient is reversed.
Ohm’s Law is also subject to a specific amount of pressure on the substance. For example placing a conductor under tension (a form of strain), causes the length of the section of conductor under tension to increase causing the cross-sectional area to decrease, hence changing the value of resistivity and conductivity.
Law of Octaves – 1863 Newlands proposed the Law of Octaves, which stated that elements repeated their chemical properties every ...
...ia Britannica. 2014. law of octaves (chemistry) -- Encyclopedia Britannica. [ONLINE] Available at:http://www.britannica.com/EBchecked/topic/424834/law-of-octaves. [Accessed 14 May 2014].
Hypothesis: As the ratio of surface area to volume of an object decreases the rate of heat loss from the object will also decrease. Objects with the same surface area to volume ratios loose heat at the same rate so long as there are not other variables involved.
There is an important relation in electricity, that is Gauss’s Law. The Gauss' law is a method widely used in electrical applications to calculate electric fields from symmetrically charged objects, it is developed by Mr. Carl Friedrich Gauss, a German mathematician and physicist.
Faraday continued his electrical experiments. In 1832, he proved that the electricity induced from a magnet, voltaic electricity produced by a battery, and static electricity was all the same. He also did significant work in electrochemistry, stating the First and Second Laws of Electrolysis. This laid the basis for electrochemistry, another great modern industry.