Wait a second!
More handpicked essays just for you.
More handpicked essays just for you.
An experiment was carried out to compare the rates of reaction between calcium carbonate and two different concentrations of hydrochloric acid
Five reason why it is important to know safety procedure in laboratory
An experiment was carried out to compare the rates of reaction between calcium carbonate and two different concentrations of hydrochloric acid
Don’t take our word for it - see why 10 million students trust us with their essay needs.
Syringe Test Experiment
Formula
Word: - Calcium Carbonate + Hydrochloric acid = Calcium Chloride +
Water + Carbon Dioxide
Symbol: - CaCOз + 2HC = CaCl + H 0 + CO
Equipment: - Flask, Glass gas syringe, Bung, Marble chips (Calcium
Carbonate (CaCOз)) and tubing.
Safety
Because of the dangerous chemical that will be handled goggles should
be wore during the experiment in case any should get in your eyes
while the chemical is being measured and the experiment is happening.
Fair test
§ The amount of hydrochloric acid is the same (20ml) for every
experiment using more or less of it in each one would highly affect it
making the results erroneous and useless.
§ The same amount of marble chips is used (2gs) for every experiment
if the amount was too varied the results would be unusable.
§ The test was repeated two times to ensure fair and accurate results
from averaging.
§ Washing each apparatus that I use so that there is no pass over of
acid or other substance.
Plan
§ Starting with a 0.25 molar.
§ Fill a flask with 5cm³ 1 molar hydrochloric acid and 15cm³ of
distilled water this will reduce the molar to 0.25.
§ The Tubing should be attached to the gas syringe and the other end
put in a bung which will be eventually be inserted in the lid of the
flask (fig 1).
§ At the last second before the bung in put on top the marble chips
(2gs) should be put in to the 2.5 hydrochloric acid so to catch the
full about of gas given off and the.
§ The temperature should be checked every 20 seconds over 200 seconds.
§ To ensure for accurate results the test should be repeated multiple
times the more times it's done the more accurate the results will be.
§ Finally you should gradually change the molar from 0.25 to 2 (0.25,
0.5, 0.75, 1, 2)
[IMAGE]
To avoid contamination as best as possible, if washing hands according to SOP1 is not possible, wearing gloves and spraying with 70% ethanol is also acceptable for the procedure. Furthermore, not touching the ends of the needle and filter are absolutely essential in avoiding contamination thus applying them to the syringe whilst the ends are still in their sterile packaging will aid the prevention of contamination. When not in use placing the syringe on its plunger creates a smaller surface area for the contaminants to attach to as well. Loosening the lids of the broth tubes before placing in the Biohazard cabinet ensures easier removal when required thus less exposure time of the opened end to the environment allowing contaminants in.
Decontamination packing and sterilization of surgical instrumentation. 2. Prosing and reposing of procedures reusable medical devices. 3. Cleaning testing assembly, and distribution of movable patient care equipment.
· If spilt on clothes or skin, wash with water to prevent harm to the
There was a series of people used in this experiment to look at blood pressure. The first step was to take the subjects normal blood pressure, then after showing them a scary clip retakes the blood pressure. While taking blood pressure consider age, weight, family history, commitment and gender to see if the subject has low or high blood pressure normally. After receiving all the data the charts that were made were based on age and gender.
We cut three potato chips to an equal length and then we set up 3
According to CDC, hand washing is the only best to reduce cross-contamination. As usually as wash my hand and don gloves in order to reduce cross-contamination. I followed evidence based practice when provided morning care and later in the afternoon when I provided perineal care for the patient.
Better infection control practices and hand washing techniques utilized by the general population help to reduce the incidences of easily avoidable conditions, such as impetigo caused by staphylococcal and streptococcal infections. It may be beneficial for public health departments to recommend teachers to teach students on how to properly wash hands and clean high contact fomites.
Disinfecting toys, surfaces, utensils, and bedding should be part of a regular routine in order to prevent the spread of germs which can cause illness.
Keeping the entire instrument clean and properly storing the device are also important in terms of maintenance.
3rd create wells: put a comb template in middle of the tray; wait until the mixture becomes solid. After,
Employees should not assume that the cleaning crew has been meticulous in eradicating germs. Phones’ and other items on the desktop are rarely cleaned or disinfected. Encourage employees to use disinfecting wipes in their personal workstation. Make wipes and hand sanitizers readily available for each workstation, especially when shared by different shifts.
daily practice of washing their bacteria laden hands in water intended for a batch of
...s and hoses, control buttons, switches, hand pieces, and X-ray units (Collins). After every patient’s visit, the operatory is to be sterilized and disinfected. All areas that were that were not covered with a barrier, or if the barrier was compromised, must be wiped down with surface disinfectants similarly used in hospitals. OSHA requires disinfectants to be potent enough to fight against HIV and HBV infections (Collins). If there is any blood present on a surface, tuberculocidal type disinfectant should be utilized.
• Washing hands after touching blood, body fluids, or other contaminated items, even when gloves are worn.
loyalties. This must be followed by a study to insure that all areas are completely cleaned