Advanced Diploma of
Building Surveying
Assignment 2 CPCCSV6005A
Services Residential and Commercial
TABLE OF CONTENTS
Chapter Page
COVER PAGE BUILT ENVIRONMENT ASSIGNMENT
TITLE ASSIGNMENT PAGE.......................................................................................................1.
TABLE OF CONTENTS........................................................................................................2.
1.0 INTRODUCTION............................................................................................................3.
2.0 FUNCTIONS OF THE BUILDING................................................................................3.
3.0 WATER SUPPLIED TO THE BUILDING ..................................................................4.
3.1 Water supply standard……………………………………………………………...4.
3.2 Percentages table…………………………………………………………………….5.
4.0 WATER USEAGE............................................................................................................5.
5.0 RUN – OFF WATER MEANS OF DISPOSAL.............................................................5.
6.0 PROBLEMS- METHODS EMPLOYED.......................................................................6.
7.0 WATER SUPPLY & RUN-OFF DISPOSAL IMPROVMENT...................................6.
8.0 CONCLUSION..................................................................................................................7.
REFERENCES..........................................................
... middle of paper ...
...e recycle system to be constantly upgraded with the latest technology when it comes on the market.
REFERENCE’S
Australian Standards 3500 (AS).National Pluming and Drainage(AS3500-1998), Sydney Australia, Standards Australia.
Australian Standards 3666 (AS). , (AS/NZS 3666 1995) Air-handling and water systems of buildings – Microbial control Sydney Australia, Standards Australia.
Building Code of Australia Volume 1 Class 2 to 9 2010 Section E ,J,F and PART A3.2, Australian Building Codes Board, Canberra ACT 2601.
Tasmanian Polytechnic CPCCSV6005A Evaluate Services Layout and Connection Methods for Residential and Commercial Buildings up to 3 Storeys- Lecture Notes
Websites
www.aihw.gov.au/WorkArea
www.dwc-water.com/.../grey-water-recycling
www.ephc.gov.au
www.sphereproject.org/dmdocuments/handbook
www.sydneywater.com.au
www.watergurus.com.au
Home Depot was founded in 1978 by Bernie Marcus and Arthur Blank in Atlanta, Georgia. With their store, Marcus and Blank revolutionized the do-it-yourself home improvement market in the United States. Home Depot began as a very basic store, operated in a large, no-frills warehouse. Home Depot carries over 35,000 products, with national brand names along with the Home Depot brand. At the start, Home Depot was able to offer exceptional customer service with knowledgeable employees who could guide customers through home renovation projects. Since its opening, Home Depot has experienced incredible growth, and today is North America's second largest retailer, and the largest home improvement retailer. Internationally, Home Depot has expanded into Canada, Mexico, and is beginning to operate stores in China. Home Depot's competition includes Sears, Ace Hardware and Lowes (the main competitor).
It was at this time that several states (QLD, NSW, Vic, and SA) began to create a more standardised building requirements, where the assessments could be carried out by local governments. As stated in (Reference 1) the benefits of a standardised building code were being seen. It was in 1965 when the Interstate Standing Committee on Uniform Building Regulations (ISCUBR) was created. Essentially this was a joint effort between the States to standardise regulations. From this, Australian construction gained the Australian Model Uniform Building Code (AMUBC) in 1971. This was established to control both technical and administrative issues, however it was based on New South Wales constructions codes, and each State varied greatly from it to suit their own
Florida International University recognizes its contribution to the accumulation of waste considering that it produces about seven million pounds of waste each year (Figueroa, 2010). Unlike other universities that still remain adamant in investing on green practices, FIU has, “governed by the State of Florida under Florida Statute 403.714 and The Florida Solid Waste Management Act of 1988” (FIU, 2011), established its own internal ‘green machine’ or solid waste and environmental protection system via the FIU Custodial Services Office. The university’s efforts in ensuring efficient solid waste management even “far exceeds the minimum standards” (FIU, 2011) required by law. What makes the solid waste management efforts of the university one-of-a kind is the establishment of a “single stream recycling program which means that all recyclable items can be placed into one bin and do not have to be sorted” (FIU, 2011). Nevertheless, despite the use of single recycle bins, proper labeling has to accompany each bin to ensure that only materials that are recyclable are placed in the bins. There are also different sized of bins which are placed stra...
A discussion on the HVAC heat loss calculations and miscellaneous supports. It was explained that the drawings showed an estimated tonnage, but the bidders were to size their units per their own calculations. The dual HVAC units as shown on the drawings represent N+1 redundancy as large VFDs are part of the building
It has also been designed to allow latitude of new technologies and innovation. People at large are invited and encouraged to be a part of the open consensus code development procedure of the IAPMO. The code is updated every three years. you can get hold of the minutest details about the code and the development timeline of the code at the website of the IAPMO. The main contents of this code include administration, definitions, general regulations, fixture fittings and plumbing fixtures, water heaters, sanitary damage, water supply and distribution, vents, indirect wastes, interceptors and traps, storm drainage, medical gas and vacuum systems and health care facilities, fuel piping, firestop protection, referenced standards, nonpotable rainwater catchment systems and alternative water sources of nonpotable
Utzon, J. (2002). Sydney Opera House Design Principles (Publication). Retrieved October 1, 2011, from http://www.heritage.nsw.gov.au/docs/nominations/operahouse_designprinciples.pdf
Paying for a foundation inspection can be worth every penny if you uncover extensive and expensive foundation damage that will cost you thousands of dollars to repair. By comparison, you are paying peanuts to find out if the home you will be buying will be a great long-term investment. You might be thinking, “I have a home inspector, why would I want to pay for a foundation repair inspector?”
Determination of the feasibility of one of the proposed service lines in the attached “Service Line Development Case Study”:
Building codes are rules for the contractors, architects, and for the owner. Basically the codes are for to protect public safety, health, and welfare in construction and buildings. The building is a law that is amendments to the builders. With out the building codes we won’t be protected in buildings. Here are some of the buildings codes.
In building construction and in fire prevention there are organizations that have created a useful system on how to determine what type of building falls under which category. The ICC (International Code Council) and the NFPA (National Fire Protection Association) create these building codes for the safety of firefighters. The two most commonly known standards for building classifications are the NFPA 5000 and also the International Building Code (IBC). The two are very similar, however, they different on sub-categorizing. The International Building Code uses Roman numerals behind the type of construction. In addition to subcategories with letters for each five classes and the amount of fire resistance provided for each building. NFPA uses Roman numerals behind the type of construction. Unlike the IBC, NFPA uses a 3-digit number system behind that to sub categorize the fire hourly rating for the load-bearing walls, for the beams and columns, and for the floor construction. The IBC and NFPA breaks down construction in to five classes, Type I, Type II, Type III, Type IV, and Type V.
I. There seem to be some background points I must go over before I can properly persuade you to recycle; this includes definitions and standard waste makeup.
For most of America, recycling has become a way of life. For some, it is a valiant effort to take charge of our waste and do what is right for the environment and for future generations. For others, it is a forced mentality by government agencies or private businesses who attempt to prove their value by self-promoting their commitment to environmental responsibility. Recycling, in theory, is a positive effort; however, massive recycling programs are not the answer. Recycling programs in general lack an intelligent way to a means, since the costs and environmental burden may outweigh the desired result. Recyclers should only focus on materials that they can process in a cost effective way, and consumers should focus
There are also several long term benefits of recycling. For example, “collecting and processing secondary materials, manufacturing recy...
Recycling is important in the effort to preserve our environment for future generations. We are running out of locations to put landfills. Recycling is a simple and effective way to reduce the amount of waste stored in landfills, yet many people do not know how easy it can be. For example, whenever I go to Shoprite® and I b...
There are 25 major specialties in engineering that are recognized by professional societies. In any one of those 25 specialties, the goal of the engineer is the same. The goal is to be able to come up with a cost effective design that aids people in the tasks they face each day. Whether it be the coffee machine in the morning or the roads and highways we travel, or even the cars we travel in, it was all an idea that started with an engineer. Someone engineered each idea to make it the best solution to a problem. Even though engineer’s goals are similar, there are many different things that engineers do within their selected field of engineering. This paper will focus on the architectural field of engineering.